Volkswagen Polo 3 with 1994 for 2001 of release.
1. The general data
1.1. New generation of cars Polo since 1995 of release
1.2. Car identification
1.3. The general recommendations about repair
1.4. Working conditions and the tool
1.5. Instructions on use of an automobile jack and other adaptations at a car raising
1.6. Car maintenance service
1.6.1. Check of level of oil and its replacement in the engine
1.6.2. Check of level of a brake liquid
1.6.3. Check of lanterns of a signal of braking
1.6.4. Illumination check
1.6.5. Pressure check in tyres
1.6.6. Check of level of a cooling liquid
1.7. Lubricants, hermetics
1.8. Work with carving connections
2. The engine
3. Greasing system
4. Cooling system
5. Systems of injection of fuel
6. Ignition system
7. Coupling
8. A mechanical transmission
9. A drive of wheels
10. A steering without the amplifier
11. A steering with the hydraulic amplifier
12. A forward suspension bracket
13. A back suspension bracket
14. Brake system
15. An electric equipment
16. Heating and ventilation system
17. An automatic transmission
18. Appendices
 













1-6-5-proverka-davleniya-v-shinakh.html

1.6.5. Pressure check in tyres

Pressure in tyres is convenient for checking a manometre and the compressor (it can be connected in a nest прикуривателя). Values of pressure are specified in the maintenance instruction. If pressure check in нагретых tyres it can be above on 20-30 кПа. In this case do not pit air to reduce pressure.
After certain run in kilometres it is necessary to check up depth of a protector of tyres. Small calibres are intended for this purpose 11 (fig. 5 see) which are established on the tyre according to fig. 10. Depth of a protector should make not less than 1,6 mm.


Fig. 5. The tool and the adaptations used at maintenance service and repair: 1 — a hydraulic jack; 2 — a butterdish; 3 — support; 4 — a portable lamp; 5 — a sampler; 6 — динамометрический a wrench; 7 — ножовка; 8 — a wire brush; 9 — lamellar measuring щупы; 10, 11 — measuring instruments of size of deterioration of tyres




Fig. 10. Measurement of depth of a protector of tyres by means of calibre






Back on page
1.6.4. Illumination check
On the following page
1.6.6. Check of level of a cooling liquid