Volkswagen Polo 3 with 1994 for 2001 of release.
1. The general data
2. The engine
3. Greasing system
4. Cooling system
5. Systems of injection of fuel
6. Ignition system
7. Coupling
8. A mechanical transmission
9. A drive of wheels
10. A steering without the amplifier
11. A steering with the hydraulic amplifier
12. A forward suspension bracket
13. A back suspension bracket
13.1. Removal and installation of a back suspension bracket
13.2. Removal and installation амортизаторных racks
13.3. Removal of rubber support of longitudinal levers
13.4. Bearings of naves of back wheels
13.5. Corners of installation of back wheels
14. Brake system
15. An electric equipment
16. Heating and ventilation system
17. An automatic transmission
18. Appendices
 





13-zadnyaya-podveska.html

13. A back suspension bracket





The back suspension bracket consists of a beam of the bridge, two twisted springs and two hydraulic shock-absorbers. Both longitudinal levers of a suspension bracket are established in rubber support. Taking into account features of installation of a nut of their fastening it is possible to tighten only in the event that the bridge beam is in horizontal position i.e. when the car is in not loaded condition. It is necessary to remember that carrying out of welding works on the back bridge and knots of its fastening is forbidden.



Back on page
12.6. A forward stretcher		 On the following page
13.1. Removal and installation of a back suspension bracket