Volkswagen Polo 3 with 1994 for 2001 of release.
1. The general data
2. The engine
3. Greasing system
4. Cooling system
5. Systems of injection of fuel
5.1. Measures on cleanliness maintenance at works on injection system
5.2. Security measures at works with injection system
5.3. Adjustment of idling and the maintenance WITH
5.4. Check of details of system of injection Mono-Motronic
5.5. A cable of management throttle заслонкой
5.6. System of catching of steams of fuel
5.7. Check and replacement of the fuel pump
5.8. The fuel filter
5.9. System of injection of design Magnetti–Marelli 1 AV (since 1996)
5.10. System of injection of fuel Motronic МР 9.0 (since 1996)
6. Ignition system
7. Coupling
8. A mechanical transmission
9. A drive of wheels
10. A steering without the amplifier
11. A steering with the hydraulic amplifier
12. A forward suspension bracket
13. A back suspension bracket
14. Brake system
15. An electric equipment
16. Heating and ventilation system
17. An automatic transmission
18. Appendices
 











5-2-mery-bezopasnosti-pri-rabotakh-s-sistemojj-vpryska.html

5.2. Security measures at works with injection system

Electronic elements of system of injection work together with ignition system. To avoid traumas and (or) damages of details of system at works, it is necessary to observe following safety measures:

The prevention
Persons with a warm stimulator cannot spend works in system of injection of fuel or the system of ignition connected with it.

- It is impossible to disconnect from clips of a wire of system of ignition or to concern with their hands at the working engine or at проворачивании the engine by means of a starter, as pressure very high;
- To disconnect electric wires of system of injection and system of ignition from clips or to attach it to clips it is possible only at the switched off ignition;
- If the engine is necessary for turning by means of a starter, without deducing it on rotation that, for example, takes place at compression check, preliminary it is necessary to take out the tip from the Hall gauge on the ignition distributor;
- помехоподавляющий the condenser cannot be attached to a clip 1 (–) ignition coils. For suppression of hindrances it is possible to use only the tips of candles protected from them resistance 5 clod;
- At start-up of the engine by means of the device of fast start-up pressure should not exceed 16,5 In, and duration of start-up no more than 1 mines;
- At clearing of the engine by a washing liquid to switch off ignition;
- At carrying out of welding works on the car irrespective of a way of welding always to disconnect wires from the storage battery.



Back on page
5.1. Measures on cleanliness maintenance at works on injection system
On the following page
5.3. Adjustment of idling and the maintenance WITH