|
6-4-3-remont-raspredelitelya-zazhiganiya.html
6.4.3. Repair of the distributor of ignitionRepair of distributors is possible only on HUNDRED, in most cases it is necessary to replace them. At repair it is necessary to observe following instructions:
- The sealing ring being under the distributor is subject to replacement if it is damaged;
- At replacement of a rotor of the distributor not to forget about a dustproof cover;
- Before replacement муфты 9 (fig. 129 see ) drive it is necessary to beat out a cylindrical lock pin 8 then it is possible to replace муфту 9 drives. But it is preliminary necessary to note position муфты on a shaft 1. At removal of a shaft of 1 distributor it is necessary to pay attention that under it there are washers 4 and 5. Their installation is made as.
|
|
Fig. 129. The ignition distributor: 1 — a shaft; 2 — a sealing ring of round section; 3 — a bolt, 3 Нм; 4 — a plastic washer; 5 — compensatory washers; 6 — the Hall gauge (G40); 7 — the case of the distributor of ignition; 8 — a cylindrical lock pin; 9 — муфта a drive
|
|