Volkswagen Polo 3 with 1994 for 2001 of release.
1. The general data
2. The engine
3. Greasing system
4. Cooling system
5. Systems of injection of fuel
6. Ignition system
7. Coupling
8. A mechanical transmission
9. A drive of wheels
10. A steering without the amplifier
11. A steering with the hydraulic amplifier
12. A forward suspension bracket
12.1. Removal and installation absorber racks
12.2. Dismantling absorber racks
12.2.1. Removal of the cross-section lever of a suspension bracket
12.2.2. Removal of a rotary fist
12.2.3. Removal of the bearing of a wheel
12.2.4. Removal of springs of a suspension bracket
12.3. Repair absorber racks
12.4. Assemblage absorber racks
12.5. Removal and installation of separate details of a suspension bracket
12.6. A forward stretcher
13. A back suspension bracket
14. Brake system
15. An electric equipment
16. Heating and ventilation system
17. An automatic transmission
18. Appendices
 













12-2-2-snyatie-povorotnogo-kulaka.html

12.2.2. Removal of a rotary fist

For removal of a rotary fist it is necessary to execute the following:

Fig. 264. Bolts and nuts of fastening of a rotary fist to absorber to a rack




- To turn away a nut of both bolts of fastening of a rotary fist to absorber to a rack. Fastening bolts are shown on fig. 264. Pay attention that position of bolts defines adjustment of disorder of wheels, therefore to them отворачивания it is necessary to note position of their heads. Cautiously to beat out bolts. It can appear that landing of bolts very hard because of jamming of a core of a bolt. If bolts it is necessary to change, adjust corners of installation of wheels;
- To get a screw-driver for an assembly ledge of the case of a rotary fist and to take out it from absorber racks;
- To check up a carving of bolts on possible damage at выбивании. In this case it is necessary to replace bolts.



Back on page
12.2.1. Removal of the cross-section lever of a suspension bracket
On the following page
12.2.3. Removal of the bearing of a wheel