12.2.1. Removal of the cross-section lever of a suspension bracket

Completely to turn away a semiaxis nut;

- To disconnect a disk of the brake mechanism from a wheel nave. It is kept by the unique bolt;

Fig. 261. A stripper for power shaft removal

- As it was specified in section 8, a shaft it is necessary выпрессовать from a rotary fist. The stripper which should be used for this purpose, is presented нарис. 261. If for выпрессовки the press it is necessary to pay attention to that at support installation the case of the bearing of a wheel has not been damaged is applied.

- To note a felt-tip pen position of heads of three bolts specified in fig. 262, on the bottom party of the lever of a suspension bracket and to turn out bolts. After that the suspension bracket lever is liberated, the spherical hinge remains in a rotary fist (the description of replacement of the spherical hinge in подразд see. 12.5).

Fig. 262. Bolts of fastening of a spherical support to the lever

Fig. 263. Fastening of the lever of a suspension bracket and the details established on it: 1 — draught of the stabilizer of cross-section stability; 2 — the plug of a support of a bar of the stabilizer; 3 — a plate with nuts; 4 — a nut, 35 Нм; 5 — the spherical hinge of a suspension bracket; 6 — bolts, 35 Нм; 7 — the stabilizer plug; 8 — a washer; 9 — a nut, 25 Нм; 10 — a bolt with шестигранной a head, 50 Нм + 90 ; 12 — дефлектор; 11, 13 — the notched rivets; 14 — a bolt with шестигранной a head, 70 Нм; 15 — a forward support of the cross-section lever of a suspension bracket; 16 — the suspension bracket lever; 17 — a back support of the lever of a suspension bracket

Fastening of the lever of a suspension bracket is shown on fig. 263, on it the arrangement of rubber plugs also is visible. Plugs are recommended to be changed in the conditions of a workshop not to admit their deformation at запрессовке.