Volkswagen Polo 3 with 1994 for 2001 of release.
1. The general data
2. The engine
2.1. Removal and engine installation
2.1.1. Removal
2.1.2. Engine and transmission installation
2.2. Dismantling and engine assemblage
2.3. A head of the block of cylinders and valves
2.4. Pistons and rods
2.5. The block of cylinders
2.6. A cranked shaft and radical bearings
2.7. A drive газораспределительного the mechanism
2.8. System of release of the fulfilled gases (ОГ)
3. Greasing system
4. Cooling system
5. Systems of injection of fuel
6. Ignition system
7. Coupling
8. A mechanical transmission
9. A drive of wheels
10. A steering without the amplifier
11. A steering with the hydraulic amplifier
12. A forward suspension bracket
13. A back suspension bracket
14. Brake system
15. An electric equipment
16. Heating and ventilation system
17. An automatic transmission
18. Appendices
 











2-1-snyatie-i-ustanovka-dvigatelya.html

2.1. Removal and engine installation




The engine raise together with a transmission and take from the car. After that the transmission can be disconnected from the engine. To perform this work, it is better to use the lift, but to take out the power unit it is possible and together.
Before to begin engine dismantle, it is necessary to execute following operations:
- To remove spring clips of hoses of system of cooling. At servicing deport for this purpose use special оправку (VAG 1921). Otherwise clips should be cut and at installation to establish collars;
- To use for engine and transmission removal elevating to a traverse;
- To get динамометрический a wrench (with a limit of measurement to 80 Нм);
- To replace cut обвязку wires with the new;
- To remember a protective code of a radio receiver if the car is equipped by it that it was possible to include again a radio receiver after connection of the storage battery. The same concerns and hours.


Back on page
2. The engine
On the following page
2.1.1. Removal