Volkswagen Polo 3 with 1994 for 2001 of release.
1. The general data
2. The engine
3. Greasing system
4. Cooling system
5. Systems of injection of fuel
6. Ignition system
7. Coupling
8. A mechanical transmission
9. A drive of wheels
10. A steering without the amplifier
11. A steering with the hydraulic amplifier
12. A forward suspension bracket
13. A back suspension bracket
14. Brake system
14.1. Adjustment of brakes
14.2. Forward disk brakes
14.3. Back drum-type brakes
14.4. The main brake cylinder
14.5. The amplifier of a brake drive
14.6. Prorolling of a hydrodrive of brake system
14.7. A regulator of pressure of brakes
14.8. A lay brake
14.8.1. Removal and installation of cables of a lay brake
14.8.2. Removal and installation of the lever of a lay brake
14.9. Antiblocking system (ABS)
15. An electric equipment
16. Heating and ventilation system
17. An automatic transmission
18. Appendices
 











14-8-1-snyatie-i-ustanovka-trosov-stoyanochnogo-tormoza.html

14.8.1. Removal and installation of cables of a lay brake

For removal and installation of cables it is necessary to execute following operations:

Fig. 310. Installation of the lever and cables of a lay brake: 1 — the lever of a lay brake; 2 — the lever handle; 3 — a decorative overlay of the lever; 4 — шестигранные nuts; 5 — the equalizer; 6 — an adjusting nut; 7 — cables of a lay brake; 8 — a counternut




- To turn away a nut 8 and 6 (fig. 310) fastenings of cables of a brake to the equalizer 5 lay brakes to turn on nuts 4 and to extend cables from the lever;
- To disconnect cables of a lay brake from levers on brake колодках after they have been disconnected from a brake board (fig. 301 see). To release cables from all knots of fastening and to take out them;

Fig. 301. Removal brake колодок. Keeping pins and a hook of fastening of the bottom returnable spring are shown by arrows




- Installation of cables of a lay brake is spent to sequences, return to removal;
- After replacement of cables in regular intervals to tighten both adjusting nuts on the equalizer of a lay brake to a tension of cables. To check up adjustment of cables and to adjust their tension.



«Back on page
14.8. A lay brake
On the following page»
14.8.2. Removal and installation of the lever of a lay brake