10.5.1. A convergence of wheels

The convergence of wheels is regulated only on the right steering draught irrespective of the fact which steering draught is established on a left-hand side — regulated or noncontrollable. A convergence of wheels to measure in the usual way, paying attention of that values are specified or in degrees and minutes, or in millimetres. Wheels should stand freely, that is, pressure should not be put upon them. The convergence of forward wheels for all models considered in the given management, makes (01,0) mm.

At change of a convergence of wheels of a spoke of a steering wheel do not settle down any more horizontally. It is connected by that one steering draught has undergone to adjustment only. If it so it is necessary to remove decorative facing of a steering wheel to remove a steering wheel and again to establish it in position for movement on a straight line. If the car is equipped by a safety pillow it is necessary to charge its removal or these works to automobile repair shop. To tighten a nut of a steering wheel the moment 50 Нм. The Same moment of an inhaling for a counternut of the hinge of steering draught. If the cuff was displaced, it is necessary to weaken compression a wire ring, to develop a cuff and again to release a ring. To check up reliability of fastening of a cuff a wire ring on all circle that it has not come off.