15.4.1. Extraction and lamp installation

Fig. 331. Headlight details: 1 — a headlight; 2 — a parking light lamp; 3 — a cartridge of a lamp of a parking light; 4 — a cover; 5 — a safety spring clip; 6 — a lamp with a double thread накаливания; 7 — the servo-driver of adjustment of range of illumination

On fig. 331 the headlight device is shown.

For extraction and lamp installation it is necessary to do the following:

- From a motor compartment to remove a protective cover;

Fig. 332. A kind of connections on a headlight inside: 1 — an electric connector; 2 — a safety clip; 3 — safety uvulas; 4 — a parking light lamp; 5 — a headlight lamp

- To disconnect an electric connector from a cartridge of a lamp of 5 headlights (fig. 332);

- To raise a safety clip 2 over both uvulas 3 and to take out a lamp from a headlight insert. Do not take a new lamp fingers. To insert a lamp so that uvulas of a cartridge of a lamp came into reflector grooves. After replacement of a lamp of a headlight always to check adjustment of headlights and in case of need to adjust. It is better to check up adjustment of headlights in car-care centre.