Volkswagen Polo 3 with 1994 for 2001 of release.
1. The general data
2. The engine
3. Greasing system
4. Cooling system
5. Systems of injection of fuel
6. Ignition system
7. Coupling
8. A mechanical transmission
9. A drive of wheels
10. A steering without the amplifier
11. A steering with the hydraulic amplifier
12. A forward suspension bracket
13. A back suspension bracket
14. Brake system
15. An electric equipment
15.1. The storage battery
15.2. The generator
15.3. A starter
15.4. Headlights
15.5. Antifog headlights
15.6. Windscreen screen wipers
15.7. Forward lanterns of indexes of turn
15.8. A back lantern
16. Heating and ventilation system
17. An automatic transmission
18. Appendices
 











15-5-protivotumannye-fary.html

15.5. Antifog headlights


Fig. 337. Fastening of an antifog headlight by bolts




Antifog headlights are established in a bumper under headlights. The order of its removal depends on bumper execution. If the bumper of the small size it is necessary to remove decorative заглушку on the bottom party and to turn away the bolts specified by arrows on fig. 337. To take out headlights from a bumper and to disconnect an electric socket on an underside.

Fig. 338. Bolts of fastening of an antifog headlight on the car with large a bumper: 1 — decorative facing




On the car with a large bumper it is necessary to disconnect decorative facing (fig. 338) from spring clips and to turn out the bolts specified by arrows. To take out a headlight and to disconnect an electric socket on an underside.
Installation of headlights of both updatings is spent to sequences, return to removal.
Antifog headlights can be regulated, is better to do it in car-care centre. The beam of light of headlights can be adjusted only in a vertical plane.

Fig. 339. An antifog lamp with the removed cover: 1 — an electric socket; 2 — a spring clip




For replacement of a lamp of an antifog headlight it is necessary to turn to the left and to remove its cover which is on an underside of a headlight. On a cover inside it is necessary to disconnect an electric socket 1 (fig. 339) from a contact uvula. To compress a spring clip 2 in a headlight over uvulas and to take a lamp (Н3, 55 Vt) from a headlight. Not to concern with fingers of a flask of a lamp. Lamp installation is spent in return sequence. The ledge of a cartridge of a lamp should be coaxial from a headlight directing in the case.




«Back on page
15.4.3. Adjustment of light of headlights
On the following page»
15.6. Windscreen screen wipers