Volkswagen Polo 3 with 1994 for 2001 of release.
1. The general data
2. The engine
3. Greasing system
3.1. Removal and installation of the oil pallet
3.2. The oil pump
3.2.1. Removal and installation of the oil pump
3.2.2. Check and repair of the oil pump
3.3. The oil filter
3.4. Check of pressure of oil
3.5. Replacement of engine oil and the oil filter
4. Cooling system
5. Systems of injection of fuel
6. Ignition system
7. Coupling
8. A mechanical transmission
9. A drive of wheels
10. A steering without the amplifier
11. A steering with the hydraulic amplifier
12. A forward suspension bracket
13. A back suspension bracket
14. Brake system
15. An electric equipment
16. Heating and ventilation system
17. An automatic transmission
18. Appendices
 













3-2-2-proverka-i-remont-maslyanogo-nasosa.html

3.2.2. Check and repair of the oil pump

The pump can be disassembled, having disconnected a cover of the pump with маслозаборником to get access to pump gear wheels. On gear wheels spend two kinds of check. At excess of maximum permissible deterioration is better to establish the new pump. Маслозаборник it is possible to wash out gasoline.
For definition of deterioration of the oil pump it is necessary:


Fig. 93. Definition of a lateral backlash between two teeths of gear wheels of the pump




- Carefully to clear the pump and to insert щуп between lateral surfaces of teeths, as is shown in fig. 93. If it is possible to insert щуп in the thickness more than 0,20 mm, means, will reach limiting deterioration. Measurement shows a lateral backlash of gear wheels which at new gear wheels makes 0,05 mm. By result of measurement it is possible to judge degree of deterioration of the pump;
Fig. 94. The control of an axial backlash of gear wheels of the pump




- To establish a goniometer on a surface of the pump and to measure щупом a backlash between a plane of a square and the top party of a gear wheel, as shown нарис. 94. If it is possible to enter щуп in the thickness more than 0,15 mm — will reach limiting deterioration, it is necessary to replace the pump;
- To take out from a cover of the pump of a detail редукционного the valve and to check up them. If details are worn out, it is necessary to replace the valve or the pump.



Back on page
3.2.1. Removal and installation of the oil pump
On the following page
3.3. The oil filter